Omega-engineering RS232 Manuel d'utilisateur télécharger pdf (Page 8)

Page 8

- In the right hand window move the slider down and until you see the ‘Network’

settings

- Before proceeding you must speak to your network administrator to get the following

information regarding the network you will be connecting the XPort device to:

• The network gateway

• The network subnet

• An available IP address.

- This should ideally be a static IP address.

- The second best would be an assigned address.

- The worst best would be a leased address with a significant time

out.

- One of the above must be found. Failure to do so could result in

problems communicating with the logger in the event of a reset of

the XPort device caused by a power failure.

- When you have an IP address from your network administrator as detailed above note it

down here __.__.__.__. This will be required when setting up communications from within

SquirrelView.

- I

f the IP address given to you by your network administrator is different from the one in the

column titled ‘IP Address’ above you must perform the following additional step:

Click the address button.

In the displayed dialog type in the IP address given to you by the network administra-

tor. Then click on the button

- Next type in the network gateway and subnet values from the network administrator in the

Network section shown in the diagram above.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Omega-engineering RS232 Manuel d'utilisateur Page 8