Omega Engineering CYD201 Manuel d'utilisateur télécharger pdf (Page 27)

OMEGA Model CYD201/CYD208 User’s Manual

Operation 3-5

3.6.2 Verifying SoftCal™ Operation

Check the status of SoftCal™ by holding

UNITS

for 2-3 seconds. If

SoftCal™ is not in operation, "-000-" displays.

If the first digit of the display is 1, SoftCal™ is set for below 28 K. If either

the second or third digit is 1, SoftCal™ is set for above 28 K.

3.6.3 Erasing SoftCal™ Compensations

When SoftCal™ compensations are erased, the thermometer returns to

normal operation.

1. Move the SET switch to position 1.

2. Hold

UNITS

until the front panel displays 0. This key is a toggle. If the

display moves in the wrong direction, release and press again.

3. Press

CAL ENABLE

on rear panel using a pen tip. The display changes

from 0 to "-SOF-". The alarm setpoint displays after erasing SoftCal™

compensation.

4. Move the SET switch to position 0.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Pas de commentaire

Omega Engineering CYD201 Manuel d'utilisateur Page 27